rs-232 reconnect button?

[Maxiq4]

so sorry bad english, I dont know already german language

normally programs works well, I just want easly reconnect.

circuit:
a pic microcontroller send some data over a bluetooth device.
I can read it from a notebook from profilab (bluetooth serial)

how its work:
I power up "first" microcontroller
then run profilab software from notebook
bluetooth automaticly connect and datas receive.. no any problem.
(I already paired bluetooth device before)

what is the problem?
if I close microcontroller (transmitter bluetooth) and re power up
profilab never reconnect automaticly, of course bluetooth connection lost.
I need close profilab and restart or I need clik right-up "connection hardware" and re click OK button.

need solution:
how can I auto connection again over rs-232 ?
or can I add a simple button like "reconnect" ??

thanks your support

[abacom]

Unfortunately ProfiLab is not prepared to recover from a loss of connection. Restarting the app is the only way.

[Mike D]

My bee a virtual serial connection like com0com between bluotooth and ProfiLab could solve the problem.

Mike

[Maxiq4]

Im trying with com0com and virtual serial port software
nothing

[Maxiq4]

dear abacom
I think profilab software need this
regards