Jump indication when wires cross

Antworten
windcrest77
Beiträge: 11
Registriert: Donnerstag 25. März 2021, 21:12

Jump indication when wires cross

Beitrag von windcrest77 » Dienstag 10. August 2021, 23:43

When two wires are crossing, SPlan is not adding the jump over symbol. Is there a setting that will make sure all crossed wires have the jump over (not connected) indication? I understand how to add the connection dot when you do want a connection. But how do I add the "not-connected" jump indication when I do not want a connection?

In the USA most schematics always indicate crossed wires as jumps (old school). I've attached an example in case I didnt ask the question well enough.
WireCrossJump.PNG
Note the wire cross indication, that is what I want to happen automatically.
WireCrossJump.PNG (6.12 KiB) 1535 mal betrachtet

e-bernd1954
Beiträge: 13
Registriert: Sonntag 7. Dezember 2014, 08:44

Re: Jump indication when wires cross

Beitrag von e-bernd1954 » Mittwoch 11. August 2021, 06:01

SPlan is a simple drawing program, the program does not recognize line crossings, it is not e-routing

Chemnitzsurfer
Beiträge: 21
Registriert: Freitag 20. Januar 2017, 14:39

Re: Jump indication when wires cross

Beitrag von Chemnitzsurfer » Donnerstag 19. August 2021, 20:42

You can also create the symbol manually and then insert it if necessary

1) create a broken line and a continuous line that crosses the first line
1.PNG
1.PNG (3.7 KiB) 1476 mal betrachtet
2) Use the Bezier curve function and create a curve/semicircle between the two parts of the broken line
22.PNG
22.PNG (5.03 KiB) 1476 mal betrachtet
3) mark the construction and create a new component from it and add it to a component library
4) If necessary, rotate the construction and also save it in the component library
3.PNG
3.PNG (22.47 KiB) 1476 mal betrachtet

e-bernd1954
Beiträge: 13
Registriert: Sonntag 7. Dezember 2014, 08:44

Re: Jump indication when wires cross

Beitrag von e-bernd1954 » Donnerstag 19. August 2021, 21:12

yes, manually build symbols and then insert them accordingly
, is a guite solution
Greetings Bernd

Antworten

Zurück zu „Thema: Schaltpläne zeichnen und bearbeiten“