Multiple Y scales for Y/t plotter
Verfasst: Montag 13. Oktober 2008, 11:39
p.erasmus
Anmeldungsdatum: 15.01.2007
Beiträge: 85
Verfasst am: 12.08.2007 11:14 Titel: Multiple Y scales for Y/t plotter
--------------------------------------------------------------------------------
Dear Abbacom
The more I use PL 4 the more I am happy with it !!
However one thing that I think or would be very usefull would be the ability to have more than one Y scale in many cases we plot say 4 signals
and all have different units it would be help full to have them displayed against different Y scales ,or is the a way to do this which I am not aware of.
Best Regards
Peter
_________________
P.Erasmus
Automotive Engineering
http://www.wenko.ch
Switzerland
Nach oben
abacom
Site Admin
Anmeldungsdatum: 30.06.2006
Beiträge: 898
Verfasst am: 16.08.2007 13:05 Titel:
--------------------------------------------------------------------------------
Well, "different scales" sounds good at first sight, but at least "different grids" would be a consequence of that as well. I guess that could look quite confusing, am I right?
Nach oben
p.erasmus
Anmeldungsdatum: 15.01.2007
Beiträge: 85
Verfasst am: 16.08.2007 16:10 Titel:
--------------------------------------------------------------------------------
Dear Abacom
I do not know about the grids I just had alook at our Labview Plotter and the grid stays the same the y axis just shows the other scales and you read the signal peak to the next scale or to its scale .
Hope it helps
Peter
Anmeldungsdatum: 15.01.2007
Beiträge: 85
Verfasst am: 12.08.2007 11:14 Titel: Multiple Y scales for Y/t plotter
--------------------------------------------------------------------------------
Dear Abbacom
The more I use PL 4 the more I am happy with it !!
However one thing that I think or would be very usefull would be the ability to have more than one Y scale in many cases we plot say 4 signals
and all have different units it would be help full to have them displayed against different Y scales ,or is the a way to do this which I am not aware of.
Best Regards
Peter
_________________
P.Erasmus
Automotive Engineering
http://www.wenko.ch
Switzerland
Nach oben
abacom
Site Admin
Anmeldungsdatum: 30.06.2006
Beiträge: 898
Verfasst am: 16.08.2007 13:05 Titel:
--------------------------------------------------------------------------------
Well, "different scales" sounds good at first sight, but at least "different grids" would be a consequence of that as well. I guess that could look quite confusing, am I right?
Nach oben
p.erasmus
Anmeldungsdatum: 15.01.2007
Beiträge: 85
Verfasst am: 16.08.2007 16:10 Titel:
--------------------------------------------------------------------------------
Dear Abacom
I do not know about the grids I just had alook at our Labview Plotter and the grid stays the same the y axis just shows the other scales and you read the signal peak to the next scale or to its scale .
Hope it helps
Peter