Design from bottom side and other feature requests
Verfasst: Dienstag 26. Juli 2022, 11:11
Hi,
Sometimes I place components on the bottom side and that leads to a lot of errors because the bottom side is mirrored. It would be nice if I can switch to bottom side in design mode (like you did in preview).
If you include this feature in new version I would buy it.
Another thing that makes it hard to produce is configuring gerber/excellon/BOM exports. Different manufacturers have different requirements and when I have to switch to different manufacturer I have to change settings. It would be nice if I can save presets with the name of the manufacturer and then recall settings when exporting to that manufacturer. This can also be passed to command line export (for automated tasks)
Sometimes I place components on the bottom side and that leads to a lot of errors because the bottom side is mirrored. It would be nice if I can switch to bottom side in design mode (like you did in preview).
If you include this feature in new version I would buy it.
Another thing that makes it hard to produce is configuring gerber/excellon/BOM exports. Different manufacturers have different requirements and when I have to switch to different manufacturer I have to change settings. It would be nice if I can save presets with the name of the manufacturer and then recall settings when exporting to that manufacturer. This can also be passed to command line export (for automated tasks)