Leave blank around the pad without using Ground plane

Antworten
burhan
Beiträge: 24
Registriert: Freitag 1. Februar 2019, 19:20

Leave blank around the pad without using Ground plane

Beitrag von burhan » Donnerstag 23. September 2021, 17:25

Hello,

How can I do that?

Bild

abacom
Site Admin
Beiträge: 3917
Registriert: Dienstag 23. September 2008, 10:54
Kontaktdaten:

Re: Leave blank around the pad without using Ground plane

Beitrag von abacom » Freitag 24. September 2021, 08:32

If you place a pad on the "automatic-Ground plane" it will have a clearance to the groundplane.
sl1.png
sl1.png (5.62 KiB) 1840 mal betrachtet
The width of this clearance can be set in the lower statusbar. You can change this value if nothing is selected, then it will be the new default value for all new elements. Or you can select a pad and then change this value only for this selected pad.
ABACOM support

K.Achim
Beiträge: 98
Registriert: Samstag 6. Oktober 2012, 15:24
Kontaktdaten:

Re: Leave blank around the pad without using Ground plane

Beitrag von K.Achim » Freitag 24. September 2021, 09:35

...and if you want pads without holes, just reduce inner diameter to zero...
SPlan 8.0, SPlan 7.0
Lochmaster 4.0
SprintLayout 6.0

burhan
Beiträge: 24
Registriert: Freitag 1. Februar 2019, 19:20

Re: Leave blank around the pad without using Ground plane

Beitrag von burhan » Samstag 25. September 2021, 17:43

Hello,

I solved the problem with "zone" (without ground plane). Thanks everyone

Bild

Antworten

Zurück zu „Thema: Lötaugen, Pads, Leiterbahnen, Masse“