S2 solder mask
Verfasst: Dienstag 11. September 2018, 09:32
Hello all, I am new to this product but I have already got the hang of it as it's quite intuitive.
I've recreated a board that was damaged by tracing over scans of the original board. All is good except for when I try and place soldermask on the lower side of the board.
On the upper side of the board I selected zones and then select "Only Soldermask" in the properties. This worked fine and shaded the area with diagonal lines.
When I do the same on the lower side of the board I get a solid yellow zone and nothing happens when I select "Only Soldermask" in properties. When I go back in to the properties the checkbox is unchecked again.
Any help would be appreciated. Thank you!
I've recreated a board that was damaged by tracing over scans of the original board. All is good except for when I try and place soldermask on the lower side of the board.
On the upper side of the board I selected zones and then select "Only Soldermask" in the properties. This worked fine and shaded the area with diagonal lines.
When I do the same on the lower side of the board I get a solid yellow zone and nothing happens when I select "Only Soldermask" in properties. When I go back in to the properties the checkbox is unchecked again.
Any help would be appreciated. Thank you!