Ground plane connection to Ground

Antworten
abacom
Site Admin
Beiträge: 3917
Registriert: Dienstag 23. September 2008, 10:54
Kontaktdaten:

Ground plane connection to Ground

Beitrag von abacom » Donnerstag 25. September 2008, 14:07

p.erasmus



Anmeldungsdatum: 15.01.2007
Beiträge: 85

Verfasst am: 14.06.2007 14:03 Titel: Ground plane connection to Ground

--------------------------------------------------------------------------------

Dear Abacom.

Please inform me whether the following is good practice and if it will function,
I would like to select the ground plane on one ground pin in the header spaceing as zero to connect the plane to actual ground ,
Will this zero spacing between the pin and the ground plane cause an electrical connection this actively takeing the plain to ground.
is this an acceptable pratice to ground the ground plane in noise enviroments.
I am just not sure if this is the correct manner to do this
Thank you
Peter
_________________
P.Erasmus
Automotive Engineering
http://www.wenko.ch
Switzerland

Nach oben


abacom
Site Admin


Anmeldungsdatum: 30.06.2006
Beiträge: 898

Verfasst am: 15.06.2007 08:07 Titel:

--------------------------------------------------------------------------------

You are absolutely right, doing it that way.

Nach oben


p.erasmus



Anmeldungsdatum: 15.01.2007
Beiträge: 85

Verfasst am: 15.06.2007 08:51 Titel:

--------------------------------------------------------------------------------

Dear Abacom
Thank you for the answer.

Best regards
Peter
_________________
P.Erasmus
Automotive Engineering
http://www.wenko.ch
Switzerland
ABACOM support

Antworten

Zurück zu „Thema: Lötaugen, Pads, Leiterbahnen, Masse“