ABACOM - ELECTRONIC SOFTWARE

Hmmm... My understanding from the help for switch delay is "When the input goes HIGH, the output will go HIGH after an adjustable interval, but only if the input stays HIGH for that time."

Thanks for the reply. I have no luck with functions that work 'immediately'... so I have found that using switch delay before the STOP helps a lot... normally I have this set to 100mS (so the signal has to be valid for this time before passing on)... Yesterday I increased this to 1 sec and have had ...

I'm being driven crazy. Every time I use the SIMULATION STOP function in a project I get 'random' stops as soon soon as I start. If I can get the project started then everything works fine. I have tried various modules like SWITCH DELAY in front of SIMULATION STOP so that the signal has to be valid ...

Hi, I'm sure this has already been discussed, but I cant find.... I've moved an old project to the new modbus client and it all works but the reaction is much slower. Before the reaction (operating a relay for example) was almost instantaneous... with the new client it takes between 3 and 6 secs... ...

Thanks for for the clear explanation... great

Hi... Sorry, complete newby... I've made a project using this function which works fine... I just can work out why it takes so long to connect. Sometimes it can take up to 22 seconds to connect. It never fails, just very slow. I cant think why it would be an issue specific to my computer. I installe...